Overlock-Stitched Stretch Sensors: Characterization and Effect of Fabric Property

Authors

  • Guido Gioberto University of Minnesota
  • Lucy E Dunne University of Minnesota

Abstract

The comfort of wearable sensors is often limited by the materials and construction methods of sensors. Here, we present a textile-based stretch sensor that is formed using a common industrial sewing machine, in an overlock formation. Swapping a single thread in the stitch for a conductive thread renders the stitch responsive to stretch through opening and closing short circuits in the looped structure of the exposed conductor. However, the sensor response is influenced by the mechanical properties of the textile to which it is stitched. We explore the influence of fiber content (with an emphasis on elastomeric fiber content) on the baseline drift, response range, and hysteresis of the stitched sensor. Results show that the sensor provides a reliable and repeatable response, with a linear region that spans from the relaxed position to between 18 and 29% elongation. Average drift of about 0.5 Ohm and hysteresis of about 1 Ohm were measured. Effects of fiber content were observed, but do not show clear relationships to percentage of elastomer content.

Author Biography

  • Lucy E Dunne, University of Minnesota
    Associate Professor Department of Design, Housing, and Apparel

Downloads

Published

2013-12-05

Issue

Vol. 8 No. 3 (2013)

Section

Peer Reviewed Article

License

By submitting a manuscript, the authors agree that the copyright of all materials published in Journal of Textile and Apparel Technology and Management (JTATM) is transferred to the publisher if and when their manuscript is accepted for publication. Please note the following details as an understanding for submitting a manuscript to JTATM for publication.
Authors grant rights to JTATM to disseminate the paper and its contents as a file on the Internet when the paper is accepted. JTATM owns an exclusive right for the paper until it is either rejected or published. The authors cannot submit the same paper in part or in its entirety to another journal during the review.
Authors retain rights to be identified as the authors when the paper is published, and the patent right or rights relating to products or processes described in the paper. The authors retain rights to the educational and research uses of the paper, such as teaching and exchange of the published or pre-publication version of the paper with colleagues, for non-commercial purposes. The authors may obtain permission from the journal for a non-exclusive use of the contents in the paper, such as tables, figures and texts, with a proper acknowledgement to the journal.
Authors must warrant the originality of the paper in that the contents of the paper in part or in full have not been published or submitted elsewhere while the paper is under review.
Effective date for the above policies is December 1, 2010. The authors of the papers published before this date will be contacted via email for copyright transfer agreements.